2007 Evinrude E-Tec 75, 90 HP outboards Service Manual, Page 184Get this manual
OILING SYSTEM PRIMING
PRIMING
WARNING
Prevent injury from contact with rotating propeller; always remove propeller before running on flushing deviceThe oiling system of the outboard must be primed if the oil tank assembly is replaced, the oiling system is run out of oil, or the system is disassembled for servicingSTART outboard and run it at IDLEUse the diagnostic software program to activate "Prime Oil
OILING RATES
EMM programming controls the rate of oil injectionUse engine diagnostics software to access this EMM feature
Oil Injection Rate
The TC-W3 OIL control setting allows the outboard to be run on TC-W3 outboard lubricantChanging to the optional XD100 OIL CONTROL setting requires the use of Evinrude XD100 outboard lubricantRunning the outboard in XD100 OIL mode can reduce oil consumption by approximately one thirdSee Oil Control on p98Two oil programming labels are provided to identify EMM oil programmingInstall the correct label to alert user to specific oil requirements