2007 Evinrude E-Tec 75, 90 HP outboards Service Manual, Page 170Get this manual
FUEL SYSTEM FUEL COMPONENT SERVICING Installation Fasten fuel pump to the cylindercrankcase with pump to crankcase screwsApply Nut Lock to screws and install screws into crankcaseTorque screws to 24 to 36 inlbs(2.8 to 4.0 Nm)Remove clamps and vapor separator cooling water hosesRemove clamps and fuel return manifold and fuel supply hose from bottom of vapor separatorRemove the vapor separator housing retainer clip1Screws 002194 1Retainer clip 005013
Connect the fuel outlet hose to the fuel filterSecure with tie strapConnect the fuel supply hose to the in-line oil supply fittingSecure with 18.5 mm Oetiker clampRoute and connect the fuel lift pump pulse hose to the crankcaseSecure with tie strapSqueeze primer bulb to prime fuel systemHold pressure on bulb and check for fuel leaksInstall lower engine covers and air silencerConnect battery cablesRun outboard and check for fuel leaks
Remove vapor separatorfuel pump from the mounting stud and slide vapor separator housing from the grooves of the isolator mounts