2007 Evinrude E-Tec 75, 90 HP outboards Service Manual, Page 72Get this manual
MAINTENANCE INSPECTION AND MAINTENANCE SCHEDULE
INSPECTION AND MAINTENANCE SCHEDULE
Routine inspection and maintenance is necessary for all mechanized productsPeriodic maintenance contributes to the product's life spanThe following chart provides guidelines for outboard inspection and maintenance to be performed by an authorized Dealer
IMPORTANT: Outboards used for rental operations, commercial applications, or other high hour use
applications require more frequent inspections and maintenanceInspection and maintenance should be adjusted according to operating conditions and use; and environmental conditionsDescription
SystemCheck self-test and warning horn, check Emergency stop circuit and lanyard, check operation Controls, steering and tilting; check operation, lubricate Engine to transom mounting hardware, re-torque (40 ftlbs Fasteners, tighten any loosened components Water intake screens, check condition Cooling system; check water pump indicatorwater pressure Anticorrosion anodes, check condition Gearcase, check condition Propeller, check condition Fuel and oil system components, inspect and repair leaks (2) Check battery connections and condition Access EMM information, resolve any service codes Electrical and ignition wires, inspect for wear or chafing Fuel filter, replace Gearcase lubricant, replace Spark plugs, inspect or replace Grease fittings, lubricate (3) Power trimtilt and fluid level, inspect Propeller shaft splines, inspect and lubricate (3) Starter pinion shaft, inspect and lubricate (3) Control cables, inspect and adjust Water pump, inspectreplace (more often if water pressure loss or overheating occurs)