2007 Evinrude E-Tec 75, 90 HP outboards Service Manual, Page 60Get this manual
INSTALLATION AND PREDELIVERY FUEL AND OIL PRIMING
Oil Supply Priming
Follow these steps for initial outboard set-up: Fill the oil tank with XD100, XD50, or XD30 oil Use the Evinrude Diagnostics Software program to confirm that the EMM is programmed for the type of oil being used Start the outboard and use the oil priming function in the software for minimum of 90 seconds to make sure the system is completely primedSTART outboard and run it at IDLEUse the diagnostic software program to activate "Prime Oil
Break-In Oiling
IMPORTANT: DO NOT add oil in the fuel tank
on Evinrude E-TEC modelsThe Engine Management Module (EMM) will automatically supply extra oil to the engine during the first two hours of operation above 2000 RPMFollow these steps for initial outboard set-up: Use the Evinrude Diagnostics Software program to confirm that the break-in program has been initiatedRefer to Oil Control on p98 The oil tank should be filled and the oil level accurately marked for reference Fill the fuel tank with the recommended fuel