2007 Evinrude E-Tec 75, 90 HP outboards Service Manual, Page 55Get this manual
INSTALLATION AND PREDELIVERY OUTBOARD RIGGING If there are not enough threads on the shift cable to allow the adjustment, or if the gearcase does not shift fully into FORWARD or REVERSE, refer to SHIFT ROD ADJUSTMENT on p265 and Shift Linkage Adjustment on p230Pull firmly on throttle cable casing to remove backlashWith engine throttle cam against stop, place the cable trunnion into the upper anchor pocket and adjust the trunnion nut so that the casing fits onto the throttle lever pin
Use long noses pliers to insert straight section
of clip into linkage pin hole1 2
1Straight section 2Angled section DP0818 DP0817
Push the clip towards the hole while lifting on Be sure retainer clip fully engages the pin Lock the retainer by moving the angled section
behind the straight sectionthe curved end with the pliers1Throttle lever pin 2Trunnion nut 002101