2007 Evinrude E-Tec 75, 90 HP outboards Service Manual, Page 10Get this manual
INTRODUCTION TYPICAL PAGE C
TYPICAL PAGE C
POWERHEAD INSTALLATION IMPORTANT: The motor mount, washer, and screw are serviced as an assemblyDo not disassembleDenotes necessary step or information to prevent damage or control correct procedure
INSTALLATION italics indicates Title in
V4 MODELS V6 MODELS
a procedure concerning Install base gasket dryDo not use Permatex particular model No2 or Gasket Sealing CompoundTitle indicates the
Apply Permatex No2 proceduresealant to inner gasket specific to V4 Models is exhaust housing flangeCoat both sides of new finishedFrom this base gasket with Gasket Sealing Compoundpoint, this particular procedure concerns V6 Models