2007 Evinrude E-Tec 75, 90 HP outboards Service Manual, Page 9Get this manual
INTRODUCTION TYPICAL PAGE B
TYPICAL PAGE B
Section Title Subsection Title Section Title
INSTALLATION AND PREDELIVERY OUTBOARD RIGGING PROCEDURE
Cable, Hose, and Wire Routing
Route all hoses, control cables, and wiring through protective sleeve or conduit into the boat and through the grommetRefer to the following diagram to ensure proper positioning of rigging components in grommet
If water pressure gauge is to be used, install the water pressure hose fitting in the cylinder blockUse Pipe Sealant with Teflon (PN 910048) on the threads of the hose fittingRefer to installation instructions supplied with gaugeRoute the water pressure hose through cover grommet with oil tank sending unit harnessRoute hose along battery cables toward the back of the powerheadUse tie straps to fasten in place
12345678910
Fuel supply hose Oil return hose Oil supply hose Battery cables Main wire harness (MWS) Throttle cable Shift cable Oil tank sending unit harness Water pressure hose Accessory charge wire