2006 SD Johnson 4 Stroke 9.9-15HP Outboards Service Manual, Page 206Get this manual
GEARCASE DISASSEMBLY
DISASSEMBLY&WARNING
Use Slide Hammer, PIN 391008, and Prop Shaft Remover, PIN 5034237, to pull out the propeller shaft bearing housing assembly
Wear safety glasses to avoid personal injury, and set compressed air pressure to less than 25 psi (172 kPa)
IMPORTANT: Clean and inspect all components during disassemblyReplace all damaged components, seals, O-rings, and gaskets upon assemblyRemove propellerRefer to Propeller Hardware Installation on p44Remove gearcaseRefer to REMOVAL AND INSTALLATION on p200Remove water pumpRefer to WATER PUMP on p202Remove two propeller shaft bearing housing retaining screws004384