2006 SD Johnson 4 Stroke 9.9-15HP Outboards Service Manual, Page 184Get this manual
MIDSECTION DRIVESHAFT HOUSING AND OIL PAN
Cleaning and Inspection
WARNING
To avoid personal injury, wear eye protection and set compressed air pressure to less than 25 psi (172 kPa) Clean all parts with cleaning solvent and dry with compressed air All nut and screw threads that are coated with Nut Lock or Screw Lock must be thoroughly cleaned before assemblyWhen using thread locking product, prime the threads with Locquic Primer Discard all oil seals, a-rings, and gasketsUse new components during assembly Check all bushings for wear and proper fitReplace if necessary Inspect the rubber motor mountsReplace if deteriorated or damaged Inspect the water tube for obstructions or kinks which may restrict water flowReplace the grommet if worn or damaged Inspect the stern brackets, swivel bracket, and steering arm for cracks and other damage Inspect the shift components for wearReplace if deteriorated or damaged Before checking the driveshaft or oil pan housings for distortion, thoroughly clean the top and bottom mating surfaces and remove all sealer and corrosion