2006 Johnson SD 30 HP 4 Stroke Outboards Service Manual, PN 5006592, Page 213Get this manual
GEARCASE BEARING AND SEAL INSTALLATION
Driveshaft Bearing Housing Seals
Use an oil seal remover or 2-jaw puller and plate assembly, PIN 432131, to draw two (2) oil seals out of the driveshaft bearing housingBe careful not to damage driveshaft bearing raceRemove the O-ring from the housing
BEARING AND SEAL INSTALLATION
Propeller Shaft Bearing
Apply HPF PRO gearcase lubricant to the bearingUsing bearing installation tool, PIN 5034774, with lettered side of bearing facing tool, carefully press bearing into housingBearing is properly installed when tool flange seats against housingO-ring