2006 Johnson SD 30 HP 4 Stroke Outboards Service Manual, PN 5006592, Page 41Get this manual
INSTALLATION AND PREDELIVERY OUTBOARD RIGGING Remove grommet from front panel
Control Cable Identification
IMPORTANT: Control cable function must be
identified before rigging outboard Identify each control cable: Put the control handle into NEUTRAL position The throttle cable casing guide will retract completely and the shift cable casing guide will go to the midpoint of its travel
1Grommet
Before installing electrical connectors, check that the seal is in placeClean off any dirt from connectorsApply light coat of Electrical Grease to the sealPush connectors together until latched1Shift cable casing guide extended to midpoint 2Throttle cable casing guide retracted