2004 SR Johnson 2 Stroke 9.9, 15, 25, 30 HP Outboards Service Manual, Page 46Get this manual
INSTALLATION AND PREDELIVERY OUTBOARD RIGGING PROCEDURE
Cable, Hose, and Wire Routing
IMPORTANT: Provide sufficient slack at outboard end to permit unrestricted steering and tilting of outboardDo not allow cables to bind
Remote Electrical Harness
9.915 MODELS
Refer to accessory instruction sheet
Battery Cables WARNING
2530 MODELS
Route electrical cable along starboard side to rear connector bracketInstall protective plug on power trimtilt connector
Disconnect battery cable from battery before servicing electrical systemsFailure to do so could result in injury from ignitions sources (sparks) or from contact with moving parts if accidental cranking or starting occursRoute battery positive (+) cable to the starter solenoidSecure the cable to terminalCover terminal with rubber boot (2530 Model) and position grommet in lower engine cover1Protective plug