2004 SR Johnson 2 Stroke 9.9, 15, 25, 30 HP Outboards Service Manual, Page 10Get this manual
INTRODUCTION TYPICAL PAGEB
TYPICAL PAGEB
Section Title
Cable, Hose, and Wire Rou mg
Route all hoses, control cables, and wiring through protective sleeve or conduit into the boat and through the grommetRefer to the following diagram to ensure proper positioning of rigging components in grommet
a water pressure gauge is to be used, install the water pressure hose fitting in the cylinder blockUse Pipe Sealant with Teflon (PIN 910048) on the threads of the hose fittingRefer to installation instructions supplied with gaugeRoute the water pressure hose through cover grommet with oil tank sending unit harnessRoute hose along battery cables toward the back of the powerheadUse tie straps to fasten in place
12345678910
Fuel supply hose Oil return hose Oil supply hose Battery cables Main wire harness (MWS) Throttle cable Shift cable Oil tank sending unit harness Water pressure hose Accessory charge wire