2003 Johnson ST 55 HP WRL 2 Stroke Commercial Service Manual, PN 5005483, Page 146Get this manual
POWERHEAD INSTALLATION Push shift lever to starboard and install retaining pin as shownConnect fuel inlet cover to fuel pump and install the manual primer assemblyRefer to FUEL SYSTEM sectionInstall the manual starter ratchetTorque the screws to 120 to 144 in Ibs(13.5 to 16 Nm)
1Shift lever retaining pin 2Shift lever
Install starter lockout cable into shift lever detent and secure with clamp
1Ratchet screws
Install manual starterSTARTER section
1Starter lockout cable clamp 2Shift lever detent
Perform the following procedures before returning the outboard to service Confirm all linkage adjustments and set low and high speed timingFor adjustment informationrefer to SYNCHRONIZATION AND LINKAGE in MAINTENANCE section Follow BREAK-IN PROCEDURE in MAINTENANCE section RUN outboard on additional oil for 10 hours of operation