2003 Johnson ST 55 HP WRL 2 Stroke Commercial Service Manual, PN 5005483, Page 11Get this manual
INTRODUCTION TYPICAL PAGEC
TYPICAL PAGEC
GEARCASE GEARCASE SERVICING
Align holes in the clutch dog with slot in the shaftInstall the clutch dog on the shaft with "PROP END" facing rear of the shaftServiced components listed in headings
IIiI'I1I'i1III
Procedure listed
IMPORTANT: The clutch dog is not symmetricalIf installed backward, it will not fully engage and will immediately damage itself and the gears
If the pinion be under component ing Remover heading assemble it as follows:
ed, use Bear391257, and
IMPORTANT: Make sure all needle bearings are in the bearing race before removing bearing