2002/2003 Johnson SN/ST 2 Stroke 3.5, 6 8 HP Outboards Service Manual, PN 5005466, Page 98Get this manual
IGNITION COMPONENT SERVICING68 to 22 inIbs(1.6 to 2.4 Nm)Repeat this step for each component installed2
Ignition Coil
Removal
Twist and remove coverRemove the spark plug and primary leads from the ignition coilsMake note of the fastener and washer locations before removing any screwsRemove the screws, coil, and washersCoil Mounting 1Fiber washer 2Flat washer(s) 3Coil ground strap 4Starwasher
DRC3630
Installation
Assemble the correct sequence of washers and locate the ignition coil on the powerheadInstall screws and torque 48 to 96 inIbs(5.4 to 10.8 Nm)Refer to diagram Apply light coating of Electrical Grease to the ribbed portion of the spark plug ceramics and to the openings of each of the spark plug lead coversInstall the spark plug leadsApply light coating of Electrical Grease to the opening of each primary lead cover and install the coversObserve proper wire routing and ignition timing Orangeblue primary lead must be connected to the number ignition coilE u