2002/2003 Johnson SN/ST 2 Stroke 3.5, 6 8 HP Outboards Service Manual, PN 5005466, Page 12Get this manual
INTRODUCTION
TYPICAL PAGEC
TYPICAL PAGEC
GEAR CASE GEARCASE SERVICING
"""!'""""i Servicedincomponents listed headings
Align holes in the clutch dog with slot in the shaftInstall the clutch dog on the shaft with "PROP END" facing rear of the shaftunder component
IMPORTANT: The clutch dog is not symmetricalIf installed backward, it will not fully engage and will immediately damage itself and the gears
-_ h_ea_d_in_g_'391257,
ed, use Bearand
IMPORTANT: Make sure all needle bearings are in the bearing race before removing bearing
V4 20 INMODELS (S-TYPE GEARCASES) Position the tool in the gearcaseUse mallet to drive the bearing from the housing