2000 Johnson/Evinrude SS 25, 35 3-Cylinder outboards Service Manual, Page 192Get this manual
Assembly
Make no dry assembliesLubricate bearings, shafts, and gears with OVIC Ultra-HPF gearcase lube
1Oil and install new bearing in aft end of the bearing housing using OVIC Bearing Installer, PI 335820Press against the lettered side of the bearing to prevent damage to the bearing when installingPress the bearing into the housing until the tool is seated on the housing2Oil and install new bearing in the forward end of the bearing housing using OVIC Bearing Installer, PI 321428Press against the lettered side of the bearing until the tool is seated on the bearing housing3Install new seals back to back in aft end ofthe bearing housing using OVIC Seal Installer, PI 335821 Apply OVIC Gasket Sealing Compound to the metal casing of the seals before installingInstall the inner seal with lip facing into the bearing housing and install the outer seal with lip facing away from the bearing housingApply OVIC Triple-Guard grease to the seal lips after installing4Lightly apply OVIC Triple-Guard grease to new bearing housing a-ringPlace the a-ring in groove ofthe bearing housing