2000 Johnson/Evinrude SS 25, 35 3-Cylinder outboards Service Manual, Page 190Get this manual
15Use OMC Bearing Puller, PI 432130, attached to OMC Slide Hammer, PI 432128, to remove the forward bearing cupSecure the puller jaws into grooves behind the cup with jaws facing port and starboardUse OMC Wrench, PIN 334359to hold the puller while tightening the jaws
[] 16Use OMC Puller Bridge, PI 432127, and OMC Small Puller, PIN 432131, to remove the driveshaft seals from the
gearcaseINotellnspect bearings in placeIf bearing is removed for any reason, it must be replaced[] 17Remove the upper driveshaft bearing
and bearing sleeve from the gearcase using the same two toolsDiscard the bearing
18To remove the pinion bearings, assemble the following components from OMC Universal Pinion Bearing Remover and Installer, PIN 391257:
PI 326582 Rod PIN 326583 Pilot Plate PIN 326577 Remover and Installer 14-20 12 inHex Head Screw 14-20 114 in Hex Head Screw