2000 Johnson/Evinrude SS 25, 35 3-Cylinder outboards Service Manual, Page 172Get this manual
[] 8Install the shift bellcrank into the exhaust housingMake sure the inside and outside bushings are seated rn
9Attach the shift lever to the bellcrankSecure with screw and washer Tighten the screw to 60-85 inIbs(7-10 Nm)
10Verify that the shift rod connector is threaded down onto the rod until seatedBack off the connector until the connector is in line with the offset in the rodInstall the shift rod into the exhaust housingPosition the rod with the offset facing to the rear
m fA11 Attach the shift rod to the bellcrank and secure with clip12Install the gearcase as described in Section 613Install the powerhead as described in Section 414Adjust shift detent as described in Section 1