2000 Johnson/Evinrude SS 25, 35 3-Cylinder outboards Service Manual, Page 164Get this manual
Installation
1Slide the protective sleeve over the stop button leadsInsert the stop button leads and the throttle cable through the lower engine cover grommet2Apply OMC Triple-Guard grease to the two steering handle bushingsPlace the bushings into the steering bracketAttach the steering handle to the steering bracketTighten the screw so the steering handle can be pivoted and maintain any positionW
3Secure stop button ground lead to the ground stud Tighten the nut securelyApply OMC Black Neoprene Dip to the stud and nut4Using OMC Insert Tool, PIN 322697, install the stop button lead into the plugConnect the 1-pin Amphenol connector Secure connector in the bracket