2000 Johnson/Evinrude SS 25, 35 3-Cylinder outboards Service Manual, Page 143Get this manual
49Remove the backing from new intake manifold gasket and install it in place on the reed box side of the manifoldRefer to the Fuel System section and install the leaf plate assemblies
rn 50.and allow to air dryApply OMC Ultraeight intake manifold Apply OMC Locquic Primer to the screws Lock adhesive to the
screwsInstall the intake manifold and secure with the screwsTighten the screws to 60-84 inIbs(7-9 Nm)
51Install the throttlespark lever to the crankcase and secure with two flat washers and shoulder boltTighten the bolt to 60-84 inIbs(7-9 Nm)the throttlespark lever and the crankcase
INote The larger of the two flat washers must be placed between
rn 52Apply atelever bushingsgrease to the inside and into the Triple-Guard outside of the two throttle Install the bushings