2000 Johnson/Evinrude SS 25, 35 3-Cylinder outboards Service Manual, Page 126Get this manual
rnelectrical Electric Models: RemoveengineRemove securing 7Tiller the two screws connector cover to the the coverthe [] 8Disconnect the stop switch wire connector Remove the stop switch wire from the ground stud[9Tiller Electric Models: Disconnect the 6-pin connector
rn 10.wires (yellowred) from Remove the twoMake sure to Tiller Electric Models: neutral start switch the connectoridentify the pin locations (2 and 6) for installation during reassembly
11Remove the throttle cable ball socket from the ball on the throttle lever using OMC Ball Socket Remover, PI 342226Remove the clip securing shift rod CD to shift leverRemove shift rod from lever12Remove the two screws Q) securing the trunnion anchor block to the engine