2000 Johnson/Evinrude SS 25, 35 3-Cylinder outboards Service Manual, Page 102Get this manual

2000 Johnson/Evinrude SS 25, 35 3-Cylinder outboards Service Manual, Page 102

[] 9Remove screw retaining the ignition coil to powerheadRemove coil with spark plug wireInstallation
rn 1Applymounting screw.Primer ignition coilNut position and OMC Locquic and OMC Lock to the ignition coil Place in
torque screw to 84-106 inIbs(9-12 Nm)

2Apply OMC Locquic Primer and OMC Nut Lock to three ignition module mounting screwsPlace ground wire Q) and lock washer under module mounting bossPosition the ignition module and torque screws to 84-106 inIbs(9-12 Nm) Place ground wire and lock washer into position and secure with screw CD tightened to 84-106 inIbs(9-12 Nm)

3Install tanblack no-oil sender lead into 2-pin Amphenol connector using OMC Insert Tool, PI 322697Connect 4-pin Amphenol connector to engine harness and secure on ignition module4Attach three primary wires to ignition coils:

Back to 2000 Johnson/Evinrude SS 25, 35 3-Cylinder outboards Service Manual