2000 Johnson/Evinrude SS 25, 35 3-Cylinder outboards Service Manual, Page 95Get this manual
Installation
1Install the flywheel key with its outer edge parallel to centerline of crankshaft and single upset mark facing down
3Align the flywheel keyway and install flywheelCoat the threads of the flywheel nut with OMC Gasket Sealing CompoundInstall the nut and torque to 100-105 ftIbs(136-142 Nm) using the flywheel holding tool as drawn on Page 3-6 and three PI 309492 screws from OMC Universal Puller Set, PI 378103, or other suitable tool to hold the flywheel
2Clean the crankshaft and flywheel tapers with OMC Cleaning Solvent and let dryThese surfaces must be clean and dry to allow proper locking of the tapers
After replacing any major ignition component, verify correct maximum spark advance using the procedure outlined in Section 1Encoder Servicing