2000 Johnson/Evinrude SS 25, 35 3-Cylinder outboards Service Manual, Page 78Get this manual
rn 3Lubricate Evinrude Outboard Lubricantcomponents all contact points and replacement with Johnson or [IQ]
Assembly
1Position the small spring on the end of the short stub of the piston and diaphragm assembly Place the large spring CD inside of the diaphragm2Position the large spring CD inside the oil mixing unit cover Compress the large spring with the coverMake sure the small spring is located over the button Q) inside the coverRotate the cover to align the cover and housing exactly as during disassemblyPress the two together and secure with two screws and washers 3Install the mixing unit bracket and secure with six screws Tighten all eight screws and to 5-7 inIbs(0,6-0,8 Nm)4Carefully install the oil piston seal into the groove in the oil piston