2000 Johnson/Evinrude SS 2 thru 8 outboards Service Manual, Page 259Get this manual
7Place ratchet on pulley8Place cover and friction spring on spindle
GIl 9Hook end of return spring in slot of friction plateInsert the
other end of return spring into hole on pulleyInstall return spring and friction plate together over spindle
10Place thrust washer on spindleInstall retaining ring with sharp side facing out
11Place rope in notch and turn pulley three turns counterclockwise from its relaxed position12Feed rope through eyelet on starter housingWhen there is still approximately 12 in(30 cm) of rope outside the starter housing, tie slipknot in the rope to hold in placeInstall motor cover panel onto starter housing