2000 Johnson/Evinrude SS 2 thru 8 outboards Service Manual, Page 200Get this manual
Exhaust Housing Servicing4 Removal and Disassembly
1The entire powerhead, exhaust housing, and gearcase may be removed from the swivel bracket as an assembly by removing four screws
2Remove the powerhead as described in Section 4m
3Remove the gearcase as described in Section 64Remove the water tube and grommet from the exhaust housing by pulling them out
m 5Remove the cotter pin and lift out the shift rod 6Remove the setscrew to separate the shift lever and the bellcrank
m 7Remove exhaust relief tube and grommet rn 8Remove over bottomrubber vibrationhousingThe plastic the two dampeners by stretching them of the exhaust