2000 Johnson/Evinrude SS 2 thru 8 outboards Service Manual, Page 179Get this manual
18Move the pistons up so the connecting rod bearings are against the crankpinPlace one bearing half between crankpin and rod and one on top of crankpinOrient and place the connecting rod cap on the needle bearingsOil threads ofthe rod cap screws Install and tighten the screws in stages to final torque of 60-70 inIbs(7-7,5 Nm) 1321
19Thoroughly clean and degrease the crankcase mating flange of the cylinder block with OMC Cleaning Solvent and let air dry20Apply OMC Locquic Primer to the mating flange of the crankcase and let air dry
1331 1341
21Apply OMC Gel-Seal" sealant to the cylinder block flangeThe application must cover the flange evenly and consistently without being excessiveThe application must not come within 14 in (6 mm) of the labyrinth seals or bearings
OMC Gel-Seal" sealant has shelf life of at least one year when stored at room temperatureTest the OMC Gel-Seal" sealant or replace it if the age of the tube can not be determinedUsing old OMC Gel-Seal II sealant could cause crankcase air leaks