2000 Johnson/Evinrude SS 2 thru 8 outboards Service Manual, Page 112Get this manual
IGNITION OUTPUT TESTSCD II All cranking output tests must be performed with spark plugs installed and torqued in the cylinder head If necessary to remove the spark plugs, be sure to keep the spark tester away from open spark plug holes
INote The following
series of steps will systematically isolate problem area in the ignition systemTo reduce your troubleshooting time and to avoid incomplete results, perform these steps in the order written
STEPTOTAL OUTPUT TEST
1Twist and remove the leads from both spark plugs1 2
rn 2Adjust leadsgapthe spark sparkleadsSecure tester clip to the on the tester to in(12 mmlConnect tester to plug
clean engine ground INotel To prevent possible arcing of high voltage, route tester
leads at least in (51 mml from any metal surface
To avoid possible shock hazard, do not handle ignition coils or spark tester during cranking tests3If equipped, install the emergency stop switch clip and lanyard assemblyCrank the engineSpark should jump each tester gap alternately If tester shows good output on both cylinders, go to STEPRUNNING OUTPUT TEST Iftester shows good output on one cylinder, go to STEPPOWER PACK OUTPUT TEST If tester shows no output, go to STEPSTOP CIRCUIT TEST