2000 Johnson/Evinrude SS 2 thru 8 outboards Service Manual, Page 109Get this manual
Ignition Component ReplacementCD II 1To avoid accidental starting of engine while servicing, twist and remove all spark plug leads&
2Remove the screws retaining the ignition component that is being replaced3Remove the wire clamp
from the ignition plate
4Loosen the five ignition plate screwsLift the ignition plate from the powerhead5Remove the plate from bottom of the ignition plate
6Remove the leads from the spiral wrap and from the ignition component7Loosely install the new ignition component on the ignition plate
rn 8Route leads and install clampplateand spiral