2000 Johnson/Evinrude SS 2 thru 8 outboards Service Manual, Page 74Get this manual
Installation INotel The air gap between the ignition module and flywheel must be verified after torquing the intake manifold screwsRefer to Section 3, Ignition Component Replacement4I Note Do not use sealer on intake manifold or carburetor gaskets& Replace any fuel hoses or fuel clamps if deteriorated or damaged1Attach the leaf plate and intake manifold using new gasketsTorque screws to 96-120 inIbs(10,8-13,6 Nm)2Using new gasket, place the carburetor in position and secure with nutsConnect the fuel hose(s) to the carburetor with tie strap using OMC Tie Strap Installation Tool, PI 3237163Install cam follower and link4Install fuel shut-off valve10119