1999 Evinrude "EE" Electric Outboards Service Manual, P/N 787021, Page 179Get this manual
3114 Inch Motor Servicing Disassembly
Before servicing any electrical parts, disconnect the battery cables from battery1Remove propeller and drive pin
armature shaft
2Mark lines across front and rear parting lines of motor for reference during reassembly3While holding motor firmly, remove thru-bolts and end cap 4While holding armature in place, remove center section Discard all O-rings5Pry seals
from end cap if worn or damaged
6Using suitable brush holder, retract brush springs and remove armature Brush plate unattached from housing for reference only
7Remove screwsdisconnect wires and remove brush plate CDRemove brushes Q) and springs