1999 Evinrude "EE" Electric Outboards Service Manual, P/N 787021, Page 145Get this manual
Pedal and Base ServiceAll Models 1To replace either the pedal or the base, remove all of the attached components as described individually in this section2Remove the steering cable as described in Steering Cable Replacement, Section 3W W
3Using pressing pin and press, remove the hinge pin attaching the pedal to the base4Install bushings in foot control base
rn 5Apply OMC Triple-Guard grease to the bushings and hinge pin6Install the hinge pin using suitable pressing pin and pressINotel Hold the wires against the pedal to prevent damage to the wires, and correctly position the wires as the pin is pressed in placeThe wires will loop up over the pin, then down to the speed control switch