1999 Evinrude "EE" Electric Outboards Service Manual, P/N 787021, Page 131Get this manual

1999 Evinrude "EE" Electric Outboards Service Manual, P/N 787021, Page 131


12Center the pivot pin in the assemblyApply OMC Screw Lockto the set screw and installTorque set screw to 40-60 in Ibs(4,5-6,8 Nm)
Cable Service 1Thread both ends of cable through motor tube bracket
1221 1231 1241 1251

2Place cable bullet in recessed area of motor tube bracket

3Route cable ends around cable drum and through each end of the deck bracketInstall washer and nut on each end of the cablePre-tighten cable nuts about equal amounts4The motortube angle adjustmentwill be close ifthe motor tube is vertical when the deck bracket is horizontal

Back to 1999 Evinrude "EE" Electric Outboards Service Manual, P/N 787021