1999 Evinrude "EE" Electric Outboards Service Manual, P/N 787021, Page 118Get this manual
10If the adjustment screw has been loosened or removed, readjust the screwRefer to Armature Shaft End Play Adjustment in this section11Refer to Bench Tests in this section to test the reassembled motorInstallation
1Standard 12-Volt and 1224-Volt ModelsPlace new D-ring in motor grooveSlide heat shrink tubes over motor wiresAttach splices to the motor wiresAttach the motor tube and adapter wires to splicesConnect motor RED wire to adapter RED wire and motor GREEN wire to motor tube BLACK wireCrimp and solder the splicesUse radiant heat source to shrink the heat shrink tubes around the splices43248