1999 Evinrude "EE" Electric Outboards Service Manual, P/N 787021, Page 100Get this manual
Installation
1Put drop of oil on the wires and pull several inches of wire through the seal
2Thread wires through adapter and push seal
into place
3Slide heat shrink tubes over RED and BLACK motor tube wiresCrimp motor tube wires to choke coil, RED to RED, and BLACK to BLACK with splices
rn 4Slide sourcetubes over splices and shrink with heat shrink suitable heat
5Solder splicesINotel Use only rosin core solderDo not use acid core solder
rn 6.tubes aover choke coil wiresof motorSlide heat Install new O-ring in groove shrink