1999 Evinrude "EE" Electric Outboards Service Manual, P/N 787021, Page 41Get this manual

1999 Evinrude "EE" Electric Outboards Service Manual, P/N 787021, Page 41

Motor Tube WiringP.W.MModels
INote To avoid damaging components or troubleshooting equipment, disconnect the battery cables before proceeding1Turn speed control variable resister to low (full clockwise looking from shaft end)

2Remove the steering housing cover3Remove light bulb

4Use an ohmmeter calibrated on high ohms scale or continuity light to test the condition of the motor tube wiring5Connect the ohmmetertest light between the RED 14-Gaand BLACK 14-Galeads: The ohmmetertest light should show low resistance or continuity If your test shows high resistance or no continuity, and motor does not operate, check Continuity TestPositive Circuit and Negative CircuitP.W.MModels, this section, and Electric Motor Assembly, Section 5

Back to 1999 Evinrude "EE" Electric Outboards Service Manual, P/N 787021