1999 Evinrude "EE" Electric Outboards Service Manual, P/N 787021, Page 40Get this manual
rn 8With the the ohmmeter between in the highest speed speed control switch the RED lead terminal position, connect "A" on the speed control and the forward reverse switch BLACK 14-Galead from the motor tube: The meter must show continuity If the meter shows no continuity, inspect the motor tube wiring for damageMotor Tube WiringResistorStandard Foot Control, Except HBF2 Models
I Note To avoid damaging components or troubleshooting equip-
ment, disconnect the battery cables before proceeding
rn 1Remove the steering housing cover2Turn speed control switch to OFF3Use an ohmmeter calibrated on low ohms scale to test the condition of the resistor assembly and motor tube wiring
4Connect the ohmmeter between the RED 14-Gaand GREEN 18-GaleadsThe meter shou Id show 0.17 -0.23 ohm resistance If measured resistance is significantly different AND motor does not respond to speed control changerefer to Resistor AssemblyExcept HBF2 in this section
rn 5Connect18-Galeads: between the GREEN 18-Gaand the ohmmeter GREENWHITE
The meter should show 0.36-0.44 ohm resistance If measured resistance is significantly different AND motor does not respond to speed control change, refer to Resistor AssemblyExcept HBF2 in this section