1999 Evinrude "EE" Electric Outboards Service Manual, P/N 787021, Page 33Get this manual
Speed Control SwitchHand Control Models
To avoid damaging components or troubleshooting equipment, disconnect the battery cables before proceeding
c:::::::::J c:::::::::J c:::::::::J c:::::::::J
The terminal numbers and their locations on the speed control switch are as shown (terminal side of switch)1Remove steering housing cover
[] 2Use 18 inAllen wrench to remove the control shaft set screwRemove the control shaft and forwardreverse lever3Unsolder and remove the RED, GREEN, and GREEN WHITE wires from terminals "2", "3", and "4" ("1", "2" and "4" on 12-volt models) of the speed control switch (and two WHITE 16-Gawires on terminals "3" and "4", 12-Volt models)Leave the WHITE 12-Gawire in place on terminal "8" during testing