1999 "EE" Outboards Accessories Service Manual, P/N 787026, Page 159Get this manual
Trim Sending Unit Adjustment It might be necessary to adjust the trim sending unit to coincide with the trim gauge at full trim-up positionTo do this, proceed as follows: 1Turn key switch to the ON position2Raise the engine with the tilt switch to maximum trim-up position
1341 1351
33-Cylinder and V4Move the angle adjusting rod to the center hole
4Loosen the sending unit screws sending unit can be pivoted
until only snug, so the
53-Cylinder and V4Lower the engine all the way down against the angle adjusting rod 6V8Lower the engine to the midpoint of the trim range