1999 "EE" Outboards Accessories Service Manual, P/N 787026, Page 158Get this manual
Installation
1Lubricate the tilt cylinder with OMC Triple-Guard grease Support the power trim unit in position and insert the tilt cylinder pin 2Install the electrical cable through the stern brackets
1301 In[1IJ In
3Insert the spring clip to the tilt cylinder pin
4Install the six bracket to manifold screwsApply OMC Nut Lock to threads of the new screwsTighten the screws to torque of 18-20 ftIbs(24-27 Nm)53-Cylinder and V4Install the angle adjusting rod in same location as removed
6V8Install the thrust rodsTighten the nuts on the two thrust rods to torque of 30-35 ftIbs(41-47 Nm)7Tighten the tilt tube nuts to torque of 50-54 ftIbs(68-73 Nm), then back off one nut 114 turn