1999 "EE" Outboards Accessories Service Manual, P/N 787026, Page 156Get this manual
18 43115
UID 20Inspect the rubber keeper on the pump drive coupling
The rubber keeper provides cushion between the motor and the pumpIf the keeper is not present, there is chance that the tang on the pump coupling could be broken off when the motor is energized21Install the pump coupling in the oil pump in the position shownUsing the two Allen head cap screws and one hex head screwflat washer, and lock washer, carefully and evenly draw the oil pump down against the manifold Tighten the screws to torque of 25-30 inIbs(2,8-3,4 NmlThe oil pump must be drawn down evenly22Snap the pump filter screen shown
into the manifold as
InI 23Position the manifold so that the pump mounting surface
is levelUsing the correct hydraulic fluid, fill the cavity where the pump is mounted, up to the top of the filter