1999 "EE" Outboards Accessories Service Manual, P/N 787026, Page 141Get this manual
v DRC6245
DRC6246A
Trim Gauge Troubleshooting
m 1Turn key switch ONUsing"G"voltmeter, check for voltage between the trim gauge "I" and terminals If no voltage, check condition of instrument harness, key switch, and engine 20-amp fuse
If voltage, go to Step 2
2Remove the whitetan lead from the trim gauge "S" terminalWith key switch ON, gauge should indicate full-trim DOWN positionNow connect jumper wire between terminalsS" and "GilGauge should indicate full -trim UP position If your results are different, replace the trim gauge If your results agree, refer to Trim Sender Troubleshooting