1999 "EE" Outboards Accessories Service Manual, P/N 787026, Page 119Get this manual
Trim Sending Unit Adjustment 1Tilt the engine and engage the mooring bracket
2Temporarily, install PIN 436541 thrust rod in the No.3
3Loosen the sending unit screws sending unit can be pivoted
until only snugso the
4Disengage the mooring bracketLower the engine against the hrust rod 5Observe the trim gaugeIf the needle does not show center positiontilt the engine up and adjust the sending unit by pivoting it up or down
6Lower the engine against the thrust rod to verify adjustmentRepeat Step 5, if necessary7After adjustment is correct, tilt the motor up, tighten the two sending unit screws, and remove the thrust rod