1999 "EE" Outboards Accessories Service Manual, P/N 787026, Page 113Get this manual
IJJ 6Using OMC Rod Holder, PI N
983213, clamp the rod tightly in viseRemove the thrust pad from the trim rod, then remove the end cap7Remove the rod from the viseUsing small screwdriver, carefully pry the scraper out of the end cap and discard it
rn 8.a-ring Discard thetool, removeand a-ring.quad-ring and the Using suitable the inner outer quad-ring
Trim Rod Reassembly
1Lubricate and install new quad-ring and scraper in the end capInstall the scraper with the bevel facing outLubricate and install new a-ring on the outside of the end cap