1999 "EE" Outboards Accessories Service Manual, P/N 787026, Page 101Get this manual

1999 "EE" Outboards Accessories Service Manual, P/N 787026, Page 101

v DRC6245
DRC6246A

Trim Gauge Troubleshooting

1Turn key switch ONUsing voltmeter, check for voltage between the trim gauge "1" and "G" terminals If no voltage, check condition of instrument harness, key switch, and engine 20-amp fuse
If voltage, go to Step 2
2Remove the whitetan lead from the trim gauge "S" terminalWith key switch ON, gauge should indicate full-trim DOWN positionNow connect jumper wire between terminals "S" and "G"Gauge should indicate full-trim UP position If your results are different, replace the trim gauge If your results agree, refer to Trim Sender Troubleshooting

Back to 1999 "EE" Outboards Accessories Service Manual, P/N 787026