1999 "EE" Outboards Accessories Service Manual, P/N 787026, Page 42Get this manual
25Install cam assemblyPosition friction cap onto adjuster screw and make sure the driveshaft pin engages cam slotSecure with flat washer and screw through the bushing
26Install friction cap nut Apply OMC Moly Lube to the throttle arm spacer and install27Install throttle arm with pin in the slot as shown to position one control cable on each side of control(If throttle arm pin is positioned in slot, both control cables will be on the same side of the control Install washer and screw and tighten securely
OMC Snap-In CablesInstallation
Throttle Cable
1Lubricate shift and throttle cable ends with OMC TripleGuard grease
rn 2Install thelocated below the in oneleverPlace the control trunnion anchor of the crescent holes (marked "OMC") throttle