1999 "EE" Outboards Accessories Service Manual, P/N 787026, Page 31Get this manual
CIVIC Snap-In Shift CableStarboard Installation
1Place casing guide through handlePush insert into casing guideInsert cable into guide and secure with screw and locknutTorque screw to 60-80 inIbs(7-9 Nm)&
2Install spring washer, then plastic washer in housingLubricate bushing and install in shift leverBe sure cable trunnion is in pocketSecure shift lever with screw and washerTorque screw to 25-35 inIbs(2,8-4,0 Nm)3Place spacer between the two housing halves and
secure halves with screwsTorque screws to 60-80 inIbs(7-9 Nm)
& 4Check that remote control operates freelyAny binding
5Install the remote control in the boatPort Installation
could cause remote control to jam when cables are attached to the motor