1999 "EE" Outboards Accessories Service Manual, P/N 787026, Page 17Get this manual
[1ID 5Install shift lockout lever
Place cam over spring washer Apply OMC Screw Lockto cam retaining screwand install the screwBe sure to align the two bosses on the cam with the two slots in the fast idle lever Install new locknut onto screw and torque screw to 25-35 in Ibs(2,8-4,0 Nm) Install keeper plate and screw Torque screw to 10-15 in Ibs(1,1 -1,7 Nm)6Place throttle lever spacer
on shift lock cam boss
7Insert bushing
in the throttle lever assembly
8Place throttle lever assembly onto shift lockout cam bossPlace countersink washer on throttle lever assembly with countersink facing outSecure throttle lever assembly using new patch lock screw; torque to 25-35 inIbs(2,8-4,0 Nm)
9If removed, install lever separator plate into housingApply OMC Screw Lock to threads of the two screws and torque screws to 10-15 inIbs(1,1-1,7 Nm)Do not operate the remote control without the separator plate installed and the two retaining screws properly torquedInstall housing bushing 10Place shift lever assembly into housingApplyOMC Moly Lube to teeth of shift lever